Kia Blind Spot Detection Not Working

Remove the foreign matter on the rear bumper.

Kia blind spot detection not working.

I was driving to work and the warning light came on blind spot radar detector blocked. If the system does not work properly a warning message will appear and the light on the switch will turn off. They did however release another notice regarding other advanced safety systems which are just as important. The bracket may break off from the bumper.

If the system does not work normally even though the foreign matter is removed take your vehicle to an authorized k900 kia dealer and have the system checked. Remove the rear bumper. If the system does not work properly a warning message will appear and the light on the switch will turn off. Once i got moving the light remained on until i got to work.

Again the company chose not to discuss vehicle speed control systems through the manufacturer communications. Disconnect the bsd connector a from the bsd unit. Remove the bsd assembly a after loosening the mounting nuts. If the system does not work normally even though the foreign matter is removed take your vehicle to an authorized kia dealer and have the system checked.

I find the main blind spot on the niro to be the front pillars especially on a left turn of say 90 degrees. Be careful when removing the blind spot detection unit. I m in northern california and was in fog mist by the coast at a standstill on the freeway due to an accident. Service bulletin tsbele154 states that the blind spot collision warning malfunctions with a dtc c270254.

If you found any problem in the bsd unit bracket or nut tightening correct the problem or replace the component. When i shut the car off it went off. And blind spot alarm is sure nice when backing out of parking spot if you are careless and not checking mirrors backup camera or looking. Of course the blind spot alarm does not alarm if you don t signal for a lane change.

When removing the bsd unit be careful not to damage the bracket of bsd.