Kenmore In Door Ice Maker Troubleshooting

Check the water supply line for damage pinching or kinks.

Kenmore in door ice maker troubleshooting.

If someone turned it off i have a different pr. Open the door to the ice maker. Flush the lines with a solution of one part vinegar and one part water. Check the water lines in the back of the refrigerator to see if there is a visible kink or clog from the hard water that flows from the house line system.

Multimeter to test it for continuity. Troubleshooting kenmore ice maker not working a faulty inlet valve may cause significant problems by delivering insufficient water. If the auger is defective it won t be abl e to push the ice out of the dispenser. Open the ice maker compartment door to access the ice maker assembly.

If the door switch does not have continuity when activated replace it. As the auger rotates it pushes the ice toward the dispenser door and down the chute. Please verify whether your house s. Check your ice maker unit and make sure it s level.

In order for the kenmore elite ice maker to operate properly the water pressure coming from the faucet should be 120 psi at the very least. The door switch turns off the ice and water dispenser when the refrigerator door is open. Check the fill cup. If the auger is broken replace it.

Check your refrigerator and make sure it s perfectly level. Refer to the installation manual for additional help with this step if needed. Make sure it s aligned correctly with the water funnel. The kenmore website provides other ways to troubleshoot your.

When the freezer door is opened the freezer door switch does two things it turns on the light in the freezer and turns off the ice maker and dispenser. Remove the ice bin. If the water pressure in your area is relatively low make sure that you use a thinner hose to connect the ice maker to the water supply. Grip the handle at the bottom of the ice bin and pull it up and out of the ice compartment housing.

Perhaps your ice maker is making ice but it s leaking water in the freezer or leaking onto the floor. Check the auger to determine if it is broken or if it is disconnected from the auger motor. If the door switch fails the dispenser will not turn on. A kenmore ice maker that is not filling with water may have a frozen or clogged water line.

I m assuming someone actually turned it on. In this case you must gently dismantle. If the refrigerator ice maker is not working the door switch might be defective. The switch can be checked for continuity with an ohm meter.

If the door switch fails the dispenser will not turn on.